CONTACT US      email    |   07 3823 1922 

IN-P Multifunction Process Indicator

IN-P Multifunction Process Indicator by Intech

Indicator for PLC and Monitoring Systems

The IN-P Multifunction Process Indicator from Intech Instruments interfaces smoothly with a wide range of PLC and monitoring systems. It has been designed specifically for use in process applications, this indicator accepts a variety of inputs.

The Intech IN-P can be configured for many different analogue inputs and functions as listed below.

Setup and calibration is simple, with on-screen, step-by-step instructions. The IN-P has a 6-digit LED display, 6 set-points and 5 front panel buttons for easy setup and operator interface. Up to 6 relay outputs, an analogue output and/or communications can also be added.

 

 

IN-P Indicator features

  • Universal Input with Indication
  • Panel Mount
  • Programmable via USB Port using uP Configure software and XU-USB (Rev 1) key
  • Simple setup and calibration
  • 6-digit LED Display
  • Option to add Two Relay Outputs (with two setpoint indicator LED’s), and One 4~20mA Analogue Output
  • Universal Power Supply of 24~250Vac / 19.5~250Vdc
  • Sensor Power Supply for powering external Transmitter
  • IP65

 

Available functions of the IN-P

A - Auto or manual scanner with alarms

B - Maths functions, (i) √ , (ii) Differnece,  (iii) Average, (iv) Hi / Lo select

C* - Hold, Tare, Reset (External switches connect to rear terminals)

D* - Flow Rate + Totalising

E* - Energy display & totaliser (flow x ΔT)

F - Step controller

G* - Auto / Manual Station

H - Retransmission

I - Other Functions - please specify

J - Data Logging

 

* Available on channel one only

 

Specifications

Power Supply HV: 85~265Vac / 95~370Vdc or LV: 15~48Vac / 10~72Vdc
Sampling Rate 10Hz
Resolution 16-bit
Accuracy 0.05% of reading
Temperature drift Typically 50ppm/°C
Calibration Factory pre-calibrated - automatic or manualuser calibration available
Security Setup is PIN code protected
Case 48 x 96 x 119.5mm / 45.5 x 92.5mm panel cutout
OPTIONAL
Relay outputs 2,4 or 6 x 5A Form A relays
Analogue output
Isolated RS485/RS232. 
Modes: ASCII, Modbus RTU slave, Ranger A
Data rates: 1200~115k2 baud
Parity: Odd, even or more
JUMPER SELECTABLE OPTIONS
Input range jumper 20mA, Custom, 2V, 10V

 

 

IN-P PDF Downloads 

Download Data Sheet

DOWNLOAD PDF  for the IN-P Multifunction Process Indicator